How do I attach an Additional Pump Module to my Nexus system?

Installation and mounting of your additional pump module with your Nexus system.

Step 1

To install your module first depower your Nexus unit and confirm all electrical connections from the washing machine are safe.



Step 2

Remove the screws from the main unit if you are connecting to this or the previous module if you are installing it as part of a chain.
Required (M4 Pozi or Phillips #2)

Step 3



Lift the covers up and hook them onto the mounts to keep them in place.

Step 4



Remove the end wedge from the last module or main unit.

Step 5



Remove the cover and end wedge from the module you want to install.

Step 6



Place the module in the slot and mark the holes to drill into the wall.

Step 7



Close the module so you can see the mounting holes.

Step 8



Mark the mounting holes on the top and bottom of the module.

Step 9



Remove the module and drill holes where you have marked. Insert the wall plugs provided in the mounting kit and reconnect the module.
Required:
M5 Pozi or Phillips #2
6MM or 15/64″ drill bit

Step 10



You can now run a reconfigure on your system to complete the removal. This is covered early in the guide under the “How do I reconfigure my Nexus System” section.


Keywords
Attach additional pump module to my Nexus system
– Attach additional pump module
– Installation
– Additional pump module
– Mounting


Still looking for additional support?

Contact Us